Latex Adhesive
JM600
A SOLVENT FREE natural rubber latex adhesive used as a general purpose carpet adhesive.
USES
Its main use is for the permanent bonding of edges and seams of traditional carpets to prevent fibre loss. It is used with hessian seaming tape (Morley product code H5) for cold seaming of carpets. It can be used with jute hessian backed carpet for “repair” of permanent bonding to subfloor.
SUBFLOORS
Suitable subfloors include concrete, sand/cement screed, smoothing underlayment, plyboard, flooring grade chipboard, hardboard, wood and existing well bonded resilient flooring. Note: There are certain grades of flooring grade chipboard that have been treated with paraffin wax to provide a waterproof quality. These types of chipboards are not suitable for use with this adhesive With existing well bonded resilient flooring care must be taken to ensure the subfloor under the resilient flooring is sound and the surface of the resilient flooring is thoroughly cleaned of any polish etc. If this cannot be done, the existing resilient flooring must be removed and the subfloor made good before proceeding.
PREPARATION
All parts of the installation should comply with the latest edition of BS 5325 The Installation of Textile Floorings. Another useful source of reference is The C F A Guide to Contract Flooring.
APPLICATION
For best results a minimum temperature of 18°C (65°F) should be maintained for the installation. Edge Sealing: apply the adhesive by brush or applicator to the edge of the carpet, having first removed any loose fibres. Allow the adhesive to fully dry before continuing with the installation. Seaming: make sure both edges of the carpet are cleanly cut and free from loose fibres; apply an even coat of JM600 to the back of the carpet and the seaming tape (Morley product code H5). Allow the adhesive to partially dry before pressing the two coated surfaces firmly together using a hand roller (Morley product code MT-100 or MT-106-SM carpet seam roller). Caution: Do not stretch the carpet until the adhesive is completely dry. It could result in the seam opening up.
HEALTH & SAFETY PRECAUTIONS
- Refer to Material Safety Data Sheet and follow the advice given.
- Ensure area of use is well ventilated.
- Avoid prolonged contact with skin and if sensitive, use barrier cream or gloves.
- In case of contact with eyes, mouth or nose, rinse with plenty of water and seek medical help.
- If adhesive is spilled, remove and dispose of it in accordance with national and local regulations for waste materials.
Technical Specifications
Product Code: Latex Adhesive
Product Name: Latex Adhesive - JM600
Type: Natural Rubber Latex
Colour: Off White
Viscosity: Approx. 4500 cps at 20°C - brush or applicator apply
Coverage: N/A
Open Time: Approximately 20 minutes depending on temperature, humidity, sub floor porosity and trowel used
Storage: Store between temperatures of 5°C and 30°C
Shelf Life: 12 months in unopened containers, stored in recommended conditions
Cleaning: Tools should be cleaned with water whilst the adhesive is wet
*Health and safety sheets available on request.